favorite
favorite
hide
unhide
flag

Posted

print

Ceramic kiln Paragon, digital, top load on stand, used - $500 (Muskegon area)

Ceramic kiln Paragon, digital, top load on stand, used 1 thumbnailCeramic kiln Paragon, digital, top load on stand, used 2 thumbnailCeramic kiln Paragon, digital, top load on stand, used 3 thumbnailCeramic kiln Paragon, digital, top load on stand, used 4 thumbnailCeramic kiln Paragon, digital, top load on stand, used 5 thumbnailCeramic kiln Paragon, digital, top load on stand, used 6 thumbnailCeramic kiln Paragon, digital, top load on stand, used 7 thumbnailCeramic kiln Paragon, digital, top load on stand, used 8 thumbnailCeramic kiln Paragon, digital, top load on stand, used 9 thumbnail
Maple Island Rd near Sterberg

google map

condition: good
make / manufacturer: Paragon
model name / number: 6165461694
size / dimensions: 6 feet tall
I bought this kiln around 6 years ago because of my bad back and although small it loads from
the front, eye level. Digital controller works well. I just fired it to 1200 degrees F and all coils
glowed, working. Important note below.
The original owner only fired this kiln 2-3 times, melted a pot in it and stopped using it. I have
fired it between 10 and 15 times with no problems. I left some of the melted clay in the corner
and simply put a 1” shelf support there and with 3 others and a full shelf as my bottom and
never had a problem firing. I suppose one could remove all the clay left in that corner and just
lay a shelf on the floor of the kiln as your bottom. That would have to be carefully done to avoid
removing any more of the floor brick. The original owner also broke off some small pieces of the
side fire brick as you see in the photos and pulled a piece of coil out on the door slightly, yet that
coil still works. None of this affected my firing of pots.
I never fired over cone 6 yet rated for around cone 10. All my firings were successful. The Orton
Vent Master works well, and I have the flexible metal exhaust hose also for it.
$500.00, cash only.
2008 Paragon Kiln Upright
Model IGUANA18
PN 736177BGT
SN 386058
240 V, Single phase
Max amps 46
Max trump 2650
Watta 10900
Extras: 7 kiln shelves (couple cracked), 2 half self pcs, tub of mixed shelf supports.
Orton Vent Master, attached in rear. Runs separately on 120V household outlet.
Catalog.
2 Piece, on a stand. Stand can be disassembled from kiln for moving.
Interior Measurements: 18 x 18 x 18 x 22” high.
NOTE: I CANNOT LIFT OR MOVE THE KILN. BUYER MUST HANDLE ALL LABOR
REQUIRED FOR THAT. IS ON GROUND FLOOR IN MY STUDIO. CANNOT DELIVER.
Will not hold unless a deposit of $100.00 is given.
First buyer here with cash or deposit gets it.
Sold as is, no warranty.
Richard Brinn

post id: 7880531764

posted:

best of [?]

loading
reading
writing
saving
searching